Batch Mode Status Messages
A.3 Batch Mode Status Messages
When programming begins, a status message informs you:
Programming at device address
where device address is the location on the device that is currently being pro- grammed. This message is updated every time the programmer starts on the next packet of data. A similar message appears when verification begins:
Reading at device address
where device address is the location on the device that is currently being read and verified. This message is updated every time the programmer starts veri- fying the next packet of data.
Upon completion of the batch execution, a message appears, informing you of the completion status.
If the operation was to program the device and was successful, the completion message is as follows:
Programming completed without errors
If the operation was to program the device but failed, the message is as fol- lows:
Errors found during programming, see error file
where error file is the file specified for the verification output.
If the operation was to verify the device and was successful, the completion message is as follows:
No errors found during verification
If the operation was to verify the device but failed, the message is as follows:
Errors found during verification, see <error file>
If the configuration/batch file contains any commands that are not recognized by the programmer, the following message appears, and programming is aborted:
Invalid batch command: unknown
where unknown is the invalid line found in the configuration/batch file.
