jTechnical Assistance Service
Troubleshooting
The cooktop is not working
The indicator light on the element is flashingE
E flashes on all the element displays and a signal sounds
The cooktop turns off by itself
Sometimes problems are unimportant technical problems that can be easily resolved. Before contacting Technical Assistance, please keep in mind the a and warnings below:
See if there is a power outage. Check to see if there is a problem with breaker for the electrical installation.
The touch key panel is heavily soiled, food has boiled over, or there is so lying on the touch key. Wipe the touch key thoroughly or remove the obje
cooktop. | Lightly | press | the corresponding touch key. | The | flashing should stop | |
The main | switch | has | been activated continuously for more than 5 | seconds. | ||
any soil on the touch | keys or remove any objects | that | are resting | on the | ||
Reset the | cooktop. |
|
|
|
| |
The power key was touched unintentionally. Press the power key again. Re cooktop.
The display flashes (there is no | Check to see whether the | saucepan is | ferromagnetic. | Check to | see whethe | |||
power) | when you place a saucepan | diameter of | the saucepan | is large | enough. Allow the | saucepan | to cool dow | |
on an | induction element | event that it | has become | too hot | when | used. |
|
|
|
|
|
| |||||
The Powerboost function display flashes and then switches off
If the display still does not light up when you switch the element off and disconnect the appliance at the circuit breaker. Wait 20 seconds and then reconnect it.
The powerboost function operates the element with the most possible power During long cooking times, it is possible that the function will switch the e to protect the cooktop from overheating. You can continue to use the cook display is not flashing.
Repairs |
| WARNING: | Repairs should | only | be | one | by | a | trained | servicer. | |||||
|
|
|
|
|
|
|
|
| d | could be at considerable risk. | |||||
|
| If your appliance is repaired improperly, you | |||||||||||||
Display E Ö and | numbers | If anE Ö | and | a series | of numbers | appear | in | the display panel, there is a f | |||||||
|
| electronic | system. Turn | the | appliance | off | and | back | on at | the | fuse or circu | ||||
|
| Call technical assistance if the same display appears again. |
| ||||||||||||
Display F and | numbers | If anF and | a number | flash | in | alternation | on | the | displays, | your | appliance ha | ||||
|
| detected | a | fault. Refer | to the | following table | for | possible | remedies. | ||||||
32
