Toshiba e-STUDIO195, 225, 245 manual Tact with the original glass

6 TROUBLESHOOTING

	Phenomenon	Usual cause	Countermeasure
The copied image is stained.		The Reversing Automatic	Lower them fully to block outside light.
		Document Feeder (optional)
		/ Automatic Document
		Feeder (optional) or the
		Platen Cover (optional) is not
		lowered fully.
		The original glass, platen	Clean them.
		sheet, scanning area or	P.204 “Daily Inspection”
		guides are dirty.
		The copy density is set	Make the density lighter if you use the
		darker.	manual copy density mode. Or use the
			automatic copy density mode.
		Highly transparent originals	Place a blank sheet of paper, the same
		such as OHP films or tracing	size as the original or larger, over the orig-
		paper are used.	inal.
The copy image is fogged.		There is a slight gap	Lower the Platen Cover (optional) or the
		between the original glass	Reversing Automatic Document Feeder
		and the original.	(optional) / Automatic Document Feeder
			(optional) fully so that the original will con-
			tact with the original glass.
		The copy paper is damp.	Replace with dry copy paper.
The density level of the copy		The transfer charger wire is	Clean the transfer charger wire.
image is uneven in a horizon-		dirty.	P.206 “Cleaning transfer charger”
tal direction.
The copy image is partially		The size or direction of the	Use copy paper of the same size as the
missing.		copy paper and the original,	original or set the reproduction ratio suit-
		or the reproduction ratio is	able to the copy paper size.
		not set properly.
		The margin for binding is too	Adjust the image shift value again.
		wide.	P.88 “Shifting Paper to Make Margin -
			IMAGE SHIFT -”

200 Before Calling Service Technician