Toshiba 182, 242, 212 manual Original/Copy paper-related items, Image trouble

Original/Copy paper-related items

Phenomenon	Usual cause	Countermeasure
An original jams.	An original not acceptable for	Check if the original is acceptable for the
	the equipment is being used.	equipment.
		P.55 “Precautions for Reversing Auto-
		matic Document Feeder (optional) / Auto-
		matic Document Feeder (optional)”
Copy paper jams.	Copy paper not acceptable	Check if the copy paper is acceptable for
	for the equipment is being	the equipment.
	used.	P.38 “Paper types not acceptable”
	The size of the copy paper in	Register the size of the placed copy paper
	the drawer or on the bypass	properly.
	tray is not registered prop-	P.47 “Preparation 3 - Registering Size
	erly in the equipment.	of Paper Placed”
		P.62 “Bypass copying”
	Jammed paper is located in	See the message on the display to
	a place you cannot see eas-	recheck the position where the paper jam
	ily.	has occurred.
		P.180 “Paper Jams”
	There is no gap between the	Adjust the gap between the side guides
	side guides and paper in the	and the paper properly.
	drawer. Or the gap is too	P.39 “Placing paper in drawers”
	wide.
Multiple feeding occurs.	Paper is clinging to each	Fan the paper well and place it again.
	other.

Image trouble

Phenomenon	Usual cause	Countermeasure
The density of the copy	Toner has run out.	“Toner empty” appears on the display
image is light.		when toner has run out. Replace the toner
		cartridge if the message appears.
		P.192 “Replacing Toner Cartridge”
	The copy density is set	Make the density darker if you use the
	lighter.	manual copy density mode. Or use the
		automatic copy density mode.
	The transfer charger wire is	Clean the transfer charger wire.
	dirty.	P.208 “Cleaning transfer charger”
The density of the copy	The copy density is set	Make the density lighter if you use the
image is dark.	darker.	manual copy density mode. Or use the
		automatic copy density mode.
The copied image is stained.	The Reversing Automatic	Lower them fully to block outside light.
	Document Feeder (optional)
	/ Automatic Document
	Feeder (optional) or the
	Platen Cover (optional) is not
	lowered fully.
	The original glass, platen	Clean them.
	sheet, scanning area or	P.206 “Daily Inspection”
	guides are dirty.
	The copy density is set	Make the density lighter if you use the
	darker.	manual copy density mode. Or use the
		automatic copy density mode.
	Highly transparent originals	Place a blank sheet of paper, the same
	such as OHP films or tracing	size as the original or larger, over the orig-
	paper are used.	inal.

Before Calling Service Technician 201