4 Replacement Procedures
4.12 FL Inverter Board
Removing the FL Inverter Board
To remove the FL inverter board, first remove the battery pack, display assembly, and display mask; then follow the steps below.
1.Remove the M2x3 black screw securing the FL inverter board to the LCD display assembly.
Figure 4-35 Removing the screw
NOTE: If a dual inverter board is installed, you must remove two additional M2.5x4 screws.
2.Disconnect the two connectors on either side of the board.
Figure 4-36 Removing the connectors
Minnesota 10A/10AG Series Maintenance Manual |
