4.ON LINE MODE
4.2 Operation
4.2Operation
4.3Reset
NOTE:
If the [RESTART] key is held for less than 3 seconds when the printer is in an error or pause state, the printer restarts printing. However, when a communication error or command error occurs, the printer returns to an idle condition.
4.4Dump Mode
When the printer is turned on, the “ON LINE” message appears on the LCD message display. It is shown during standby or normal printing.
1.The printer is turned on, standing by, or printing.
21/,1(
2.If any error occurs during printing, an error message appears. The printer stops printing automatically. (The number on the right column shows the number of unprinted media.)
123$3(5
3.To clear the error, press the [RESTART] key. The printer resumes printing.
21/,1(
4. If the [PAUSE] key is pressed during printing, the printer stops printing temporarily. (The number on the right column shows the number of unprinted media.)
3$86(
5.When the [RESTART] key is pressed, the printer resumes printing.
21/,1(
Reset operation clears the print data sent to the printer from the computer, and returns the printer to an idle condition.
1.The printer is turned on, standing by, or printing.
21/,1(
2.To stop printing, or clear the data sent from the computer, press the [PAUSE] key. The printer stops printing.
3$86(
3.Press and hold the [RESTART] key for 3 seconds or longer.
!5(6(7
4.Press the [PAUSE] key. The data sent from the computer will be cleared, and the printer returns to an idle condition.
21/,1(
In Dump mode, any characters sent from the host computer will be printed. Received characters are expressed in hexadecimal values. This allows the user to verify programming commands and debug the program.
And for other details, please refer to your nearest TOSHIBA TEC service representative.
4- 2
