5. MAINTENANCE
5.2 Care/Handling of the Media and Ribbon
5.1.2Covers and Panels Wipe the Cover and Front Panel with a dry soft cloth. Wipe off dirt with
a soft cloth slightly moistened with water.
CAUTION!
Do not use any volatile solvents including thinner and benzene, as this may cause discoloration or distortion of the cover.
5.1.3Optional Cutter Module 1. Remove the Plastic Head Screws and to detach the Cutter Cover.
2.Remove the jammed paper and trash, if any.
WARNING! | 3. Clean the Cutter Blade with a dry cloth. | |
1. Be sure to turn the |
| |
power off before | Fixed Cutter | |
cleaning the Cutter | ||
Module. |
| |
2. The Cutter is sharp, so | Swing Cutter | |
care should be taken | ||
Cutter Unit | ||
not to injure yourself |
| |
when cleaning. |
|
Plastic Head Screw
Plastic Head Screw
Cutter Cover
5.2Care/Handling of the Media and Ribbon
CAUTION!
Be sure to carefully review and understand the Supply Manual. Use only media and ribbons which meet specified requirements. Use of
∙Do not store the media and ribbon for longer than the manufacturer’s recommended shelf life.
∙Store media rolls on the flat end. Do not store them on the curved sides as this might flatten that side causing erratic media advance and poor print quality.
∙Store the media in plastic bags and always reseal after opening. Unprotected media can get dirty and the extra abrasion from the dust and dirt particles will shorten the print head life.
∙Store the media and ribbon in a cool, dry place. Avoid areas where they would be exposed to direct sunlight, high temperature, high humidity, dust or gas.
∙The thermal paper used for direct thermal printing must not have specifications which exceed Na+ 800 ppm, K+ 250 ppm and Cl- 500 ppm.
∙Some ink used on
For further information, please contact your local distributor or your media and ribbon manufacturers.
5- 2
