3. PRINTER OPERATION |
3.4 Using the
3.4.8 Stock Tab (Cont.)
NOTE:
Before executing any large print runs, confirm that any increased speed settings specified do not result in unacceptable output quality.
When a cutter is installed on the printer, the Cut option is used to enable the cutter operation and specify how often labels should be cut. The following settings are available for the Cut option.
∙Disabled. This is the default setting.
∙After Every Label. Cuts labels after each label is finished printing.
∙After Entire Job. Cuts labels only after the entire print job is finished
printing.
Specified Interval. Cuts labels after the number of labels specified in the Interval setting. The interval setting window will appear to the right after clicking on Specified Interval to allow entering in the number of labels for
the interval.
Print Speed - When clicking on the arrow of the Print Speed: scrolling text box, it will allow the print speed selections of either 2 inches per second or 4 inches per second.
Fine Adjustment – Allows for adjusting the following parameters. Click on the Set check box to enable setting fine adjustments through this property page. If not checked, the fine adjustments are grayed out and cannot be changed.
∙Feed - Specifies the length of label stock that will feed after printing.
∙Backfeed - Specifies the length of label stock that is retracted before printing. This entry window is only available in cut or strip mode.
∙Cut/Strip Adjustment - When cutting, this specifies the length of label to feed before cutting the label. This entry window is only available in cut mode.
Print Shrinkage - Used to compensate for label print shrinkage or expansion.
