Toshiba B-850 owner manual Product Overview, Introduction, Features Unpacking

1. PRODUCT OVERVIEW

EO1-33029

1.1 Introduction

1. PRODUCT OVERVIEW

1.1 Introduction

Thank you for choosing the TEC B-852 series label/tag printer. This Owner’s Manual contains valuable information from general set-up to how to confirm the printer's operation using a test print, and should be read carefully to help gain maximum performance and life from your printer. This manual should be kept close at hand for everyday reference. Please contact your TOSHIBA TEC representative for further

information concerning this manual.

1.2 Features

1.3 Unpacking

NOTES:

∙Check for damage or scratches on the printer. However, please note that TOSHIBA TEC shall have no liability for any damage of any kind sustained during transportation of the product.

∙Keep the cartons and pads for future transportation of the printer.

The B-852 printer has the following features:

∙A 8.3 inch wide print head installed in such a compact body that the size of the printer body (except the Supply Holder Unit) is about 1/3 of the B-872 printer.

∙The print head block can be fully opened to provide accessability.

∙Various kinds of media can be used since the black mark sensors are located above and under the media passage, respectively, and the media sensors can be moved from the center to the left edge of the media.

∙When the optional interface board is installed, Web functions such as remote maintenance and other advanced network functions are available.

∙Superior hardware, including the specially developed 300 dots/inch (11.8 dots/mm) thermal print head which allows very clear print quality at a print speed of either 2 inches/sec. (50.8 mm/sec.) or 4 inches/sec. (101.6 mm/sec.).

∙Besides the optional cutter module, there is also an optional PCMCIA Interface Board, Expansion I/O Interface Board, PCL5 Interface Board Kit, and the KB-80-QM Keyboard Unit.

Unpack the printer as per the Unpacking Instructions supplied with the printer.

1- 1