APPENDIX 4 SYSTEM MODE
A4.4 Printer Parameter Fine Adjustment
A4.4 Printer Parameter Fine Adjustment (Cont.)
NOTES:
∙ When pressing the [FEED] |
and [RESTART] keys at the |
same time in the parameter |
setting, the message returns |
to “<3>ADJUST SET”. |
∙ If holding the [FEED] or |
[RESTART] key for 0.5 |
seconds or longer in the |
Printer Parameter Fine |
Adjustment, the key is |
entered continuously. |
∙ A changed parameter |
becomes enabled by pressing |
While pressing the [FEED] and [PAUSE] keys at the same time, turn on the printer. Holder both keys until the “<1>DIAG. Vx.x” Message appears.
!',$*9[[
Press the [FEED] key.
The printer is at the start of the Printer Parameter Fine Adjustment menu.
Feed Length Fine Adjustment
With this parameter you can fine adjust the feed length. When “<3>ADJUST SET” appears, press the [PAUSE] key.
the [PAUSE] key and is |
stored in memory until the |
printer is turned off. |
∙ Use the [FEED] or |
[RESTART] key to select a |
desired value or option. |
Feed Length Fine Adjustment (Example)
[RESTART]
[FEED]
NOTE:
The fine adjustment value equals the sum of the fine adjustment values set by the PC command and this parameter. The maximum feed length fine adjustment value is ±50.0mm. When the value reaches the maximum, the value remains unchanged even if the subsequent fine adjustment is performed.
[FEED] key: Pressing the [FEED] key one time causes a
[RESTART] key: Pressing the [RESTART] key one time causes a +0.5mm change, up to +50.0 mm.
After completing the fine adjustment, press the [PAUSE] key.
A4- 6
