6. TROUBLESHOOTING
6.4 Threshold Setting
6.4 Threshold Setting
NOTES:
1.If the [PAUSE] key is released within 3 seconds while in pause state, paper will not feed.
2.Failure to feed more than 1.5 labels may result in an incorrect threshold setting.
3.While the Print Head Block is raised, the [PAUSE] key does not work.
4.Errors such as paper end and cutter error are not detected during paper feed.
5.Selecting the Transmissive Sensor(for
6.If using the transmissive sensor and the printer continues to print out of position even after setting the threshold, adjust the Feed Gap Sensor in the system mode. Reset the threshold again. Make sure that the Transmissive Sensor (for
To maintain a constant print position the printer uses the Transmissive Sensor to detect the gap between labels by measuring the amount of light passing through the media. When the media is
„Threshold setting procedure
1.Turn the power ON. The printer is in stand by mode.
21/,1(
2.Load a media roll.
3.Press the [PAUSE] key.
3$86(
4.The printer enters the pause mode.
5.Press and hold the [PAUSE] key for at least 3 seconds in the pause state.
75$160,66,9(
6.The sensor type is displayed.
7.To select the Reflective Sensor (Black Mark Sensor), press the
[FEED] key.
5()/(&7,9(
8.To select the Transmissive Sensor (Feed Gap Sensor), press the [FEED] key again.
75$160,66,9(
9.Press and hold the [PAUSE] key until more than 1.5 labels (tags) have been advanced.
The media is advanced until the [PAUSE] key is released. (Threshold setting is completed by this operation.)
3$86(
10.Press the [RESTART] key.
21/,1(
11.The printer is in
12.Send an issue command from the PC to the printer.
21/,1(
6- 4
