2. PRINTER SETUP

EO1-33029

2.8 Setting Sensor Positions

2.8Setting Sensor Positions

2.8.1Setting the Feed Gap Sensor

After loading the media, as outlined in the previous paragraphs, it will then be necessary to set the Media Sensors used to detect the print start position for label or tag printing.

1.With the Print Head Block raised as described in section 2.7.3, pass the labels under the Upper Sensor Ass’y as shown in the figure below.

2.Rotate the Green Sensor Adjust Gear to move the Sensor Ass’y to the left or right to center the arrow ( ) over the label.

3.With the sensor set to the center of the labels, it will best detect the gap between labels even if the labels are round.

Green Sensor

Adjust Gear

Upper Sensor Ass’y

2.8.2Setting the Black Mark Sensor

1.If the Black Mark is printed on the top of the tag media then simply rotate the Green Sensor Adjust Gear to move the Sensor Ass’y so that

the Black Mark Indicator () is directly in line with the Black Mark on the top of the paper.

2.If the Black Mark is printed on the bottom of the tag media then fold the media back to be able to see the Black Mark and its relationship to the Sensor Ass’y as shown in the figure below.

Green Sensor

Adjust Gear

Upper Sensor Ass’y

2-12

Page 22
Image 22
Toshiba B-852-TS12-QQ owner manual Setting Sensor Positions, Setting the Feed Gap Sensor, Setting the Black Mark Sensor