Toshiba B-852-TS12-QQ owner manual Inserting the Optional Pcmcia Cards, Com

2. PRINTER SETUP

EO1-33029

2.10 Inserting the Optional PCMCIA Cards

2.10Inserting the Optional PCMCIA Cards

CAUTION!

1.To protect PC cards, discharge static electricity from your body by touching the metal cabinet of the printer before touching the card.

2.Before inserting or removing a PCMCIA card make sure that the printer’s power is turned off.

3.Be sure to protect PCMCIA Cards when not in use by putting them into their protective covers.

4.Do not subject the card to any shocks or excessive force nor expose the card to extremes in temperature or humidity

5.The card may be inserted into the slot halfway even in the wrong orientation. However, the slot is safety designed so that the card will not seat against the connector pins.

When the optional PCMCIA interface board is installed into the B-852 printer, there will be two PCMCIA slots available as shown in the figure below. This allows for the use of Flash Memory Type Cards or I/O type Cards such as LAN Cards. The following paragraphs outline how to insert PCMCIA cards.

1.Make sure that the printer’s power switch is in the OFF position.

2.Hold the PCMCIA Card so that the model name printed side faces right. Insert the card into the proper slot until the Eject Button pops out.

Slot 0:

(Memory type cards only)

Slot 1:

(I/O type cards such as LAN cards)

Eject Button

Model Name Printed Side

3.The following PCMCIA cards can be used.

Type	Maker	Description		Remarks
ATA Card	San Disk	A card conforming to
		the PC card ATA		----------
	Hitachi
		standard
				Install into the slot
LAN Card	3 COM	Ether Link III		(1) only. (This card
		3C589D PC card		installed into the slot
				(0) will not work.)
Flash
		EF-4M-TB	CC
Memory	Maxell			----------
Card (4 MB)		EF-4M-TB	DC

2-14