1. PRODUCT OVERVIEW EO1-33029
1.1 Introduction
1- 1
1. PRODUCT OVERVIEW
1.1 Introduction
1.2 Features
1.3 Unpacking
Thank you for choosing the TEC B-852 series label/tag printer. This
Owner’s Manual contains valuable information from general set-up to
how to confirm the printer's operation using a test print, and should be
read carefully to help gain maximum performance and life from your
printer. This manual should be kept close at hand for everyday reference.
Please contact your TOSHIBA TEC representative for further
information concerning this manual.
The B-852 printer has the following features:
• A 8.3 inch wide print head installed in such a compact body that the
size of the printer body (except the Supply Holder Unit) is about 1/3
of the B-872 printer.
• The print head block can be fully opened to provide accessability.
• Various kinds of media can be used since the black mark sensors are
located above and under the media passage, respectively, and the
media sensors can be moved from the center to the left edge of the
media.
• When the optional interface board is installed, Web functions such as
remote maintenance and other advanced network functions are
available.
• Superior hardware, including the specially developed 300 dots/inch
(11.8 dots/mm) thermal print head which allows very clear print
quality at a print speed of either 2 inches/sec. (50.8 mm/sec.) or 4
inches/sec. (101.6 mm/sec.).
• Besides the optional cutter module, there is also an optional PCMCIA
Interface Board, Expansion I/O Interface Board, PCL5 Interface
Board Kit, and the KB-80-QM Keyboard Unit.
Unpack the printer as per the Unpacking Instructions supplied with the
printer.
NOTES:
• Check for damage or
scratches on the printer.
However, please note that
TOSHIBA TEC shall have
no liability for any damage
of any kind sustained during
transportation of the
product.
• Keep the cartons and pads
for future transportation of
the printer.