APPENDIX 4 SYSTEM MODE
A4.1 Operation Panel
APPENDIX 4 SYSTEM MODE
IMPORTANT!
If System Mode is needed for any other purposes, please contact a TOSHIBA TEC authorized service representative before performing any operation in System Mode.
A4.1 Operation Panel
Appendix 4 describes usage and purpose of the keys on the Operation Panel in System Mode.
For end users, System Mode should be used for the following four purposes:
∙To check and print the system status, the Maintenance Counter, and the Print Head Element.
∙To make fine adjustment related to the media issue.
∙To perform a test print for checking print quality.
∙To set the parameters for the PCL Emulation.
The figure below illustrates the Operation Panel and key functions.
LCD Message Display
POWER LED (Green)
[RESTART] key
[FEED] key
POWER ONLINE ERROR
FEED RESTART PAUSE
ERROR LED (Red)
ON LINE LED (Green)
[PAUSE] key
NOTE:
Use the [RESTART] key to
The LCD Message Display shows messages in alphanumeric characters and symbols to indicate the printer’s status. Up to 16 characters can be displayed on one line.
There are three LEDs on the Operation Panel.
LED | Illuminates when… |
POWER | The printer is turned on. |
ON LINE | The printer is ready to print. |
ERROR | Any error occurs with the printer. |
In System Mode, the [FEED], [RESTART] and [PAUSE] keys function as described below.
Used to start the system mode as a [RESTART] key
FEED does. Used to select the parameter mode or to fine adjust the parameters in the negative direction
resume printing after a pause
condition, or after clearing
RESTART
Used to select the parameter mode or to fine adjust the parameters in the positive direction (+).
an error.
PAUSE | Used to start the system mode as a [FEED] key does. |
Used to select the parameter mode. Used as an enter | |
| key. |
A4- 1
