Toshiba B-852-TS12-QQ owner manual Cut Position Fine Adjustment

APPENDIX 4 SYSTEM MODE

EO1-33029

A4.4 Printer Parameter Fine Adjustment

A4.4 Printer Parameter Fine Adjustment (Cont.)

Cut Position Fine Adjustment (Example)

Cut Position Fine Adjustment

With this parameter you can fine adjust the cut position. When “<3>ADJUST SET” appears, press the [PAUSE] key twice.

&87￿$'-￿￿￿￿￿￿PP￿

NOTES:

[RESTART]

[FEED]

&87￿$'-￿￿￿￿￿￿PP￿

&87￿$'-￿￿￿￿￿￿PP￿

&87￿$'-￿￿￿￿￿PP￿

&87￿$'-￿￿￿￿￿￿PP￿

&87￿$'-￿￿￿￿￿￿PP￿

∙Cut issue is available only when the optional cutter unit (B-7208-QM) is installed. When you need the cutter, please contact your nearest TOSHIBA TEC service representative.

∙The fine adjustment value equals the sum of the fine adjustment values set by the PC command and this parameter.

The maximum cut position fineadjustment value is ±50.0mm. When the value reaches the maximum, the value remains unchanged even if the subsequent fine adjustment is performed.

[FEED] key: Pressing the [FEED] key one time causes a –0.5mm change, up to –50.0 mm.

[RESTART] key: Pressing the [RESTART] key one time causes a +0.5mm change, up to +50.0 mm.

After completing the fine adjustment, press the [PAUSE] key.

A4- 7