APPENDIX 1 MESSAGES AND LEDS ENGLISH VERSION EO1-33055
APPENDIX 1 MESSAGES AND LEDS
EA1- 1
APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
4: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
LED Indication
No. LCD Message POWER ONLINE ERROR Printer Status
Restoration
by RESTART
key Yes/No
Acceptance of
Status Request
Reset Command
Yes/No
ON LINE z In online mode ----- Yes
1 ON LINE ~ z In online mode (The printer in
communication) ----- Yes
2 HEAD OPEN z z The print head block is opened in online
mode. ----- Yes
3 PAUSE **** z z The printer is paused. Yes Yes
4 COMMS ERROR z
A parity, overrun, or framing error has
occurred during communication through
the RS-232C.
Yes Yes
5 PAPER JAM **** z The media is jammed during paper feed. Yes Yes
6 CUTTER ERROR**** z A problem has occurred with the cutter
module. Yes Yes
7 NO PAPER **** z
The media has run out, or the media is
not loaded on the supply holder
properly.
Yes Yes
8 RIBBON ERROR**** z
The ribbon has run out, or has been torn.
A problem has occurred with the sensor
that determines the torque for the ribbon
motor.
Yes Yes
9 HEAD OPEN **** z Feed or printing was attempted with the
print head block open. Yes Yes
10 HEAD ERROR z There is a problem with the print head Yes Yes
11 EXCESS HEAD TEMP z The print head is overheated. No Yes
12 SAVING ###&&&& z In writable character or PC command
save mode ----- Yes
13 FLASH WRITE ERR. z An error has occurred while writing to
flash memory. No Yes
14 FORMAT ERROR z An erase error has occurred in
formatting the flash memory. No Yes
15 FLASH CARD FULL z Data cannot be stored because the flash
memory. No Yes
16 POWER FAILURE z A power failure has occurred. No No
17 MEM. INTIAL… z z A flash memory card is being initialised. ----- -----
18 EEPROM ERROR z Data cannot be read from/written to a
backup EEPROM properly No No