Toshiba B-852 Dump Mode Setting, After selecting the receive buffer, press the Pause key

2. PRINTER SETUP

ENGLISH VERSION EO1-33055

2.9 Setting an Operating Environment

2.9.2Dump Mode Setting

While “<4>DUMP MODE” is displayed on the LCD Message Display, press the [PAUSE] key to enter the Dump Mode.

In the Dump Mode, data in the receive buffer are printed. Data are expressed in hexadecimal values. This operation allows the user to verify programming commands or debug the program.

When “<4>DUMP MODE” appears, press the [PAUSE] key.

BUFFER RS-232C

Use the [FEED] or [RESTART] key to choose a receive buffer to be dumped.

[RESTART]

[FEED]

BUFFER RS-232C

BUFFER CENTRO.

BUFFER NETWORK

BUFFER BASIC 1

BASIC Interpreter (Interface → Interpreter buffer)

BUFFER BASIC 2

BASIC Interpreter (Interpreter → Printer buffer)

BUFFER USB

NOTES:

After selecting the receive buffer, press the [PAUSE] key.

PRINT ON DEMAND

Use the [FEED] or [RESTART] key to select a printing method.

1.When “ON DEMAND” is selected, it is required to choose a

printing method again and press the [PAUSE] key to print the subsequent data until the all data has been printed.

2 If an error occurs during

dumping, the printer will display

an error message and stop

[RESTART]

[FEED]

PRINT ON DEMAND

Prints 166 lines of data (approx. 50cm), then stops.

*To print the subsequent data, choose a printing method again and press the [PAUSE] key.

PRINT ALL

printing. The error can be

cleared by pressing the [PAUSE]

key, and then the display will

show “<4>DUMP MODE”

again.

After a recovery from the error

the printer will not start printing

automatically.

Prints all data in the receive buffer, then stops.

After selecting a printing method, press the [PAUSE] key.

NOW PRINTING...

[PAUSE]

<4>DUMP MODE

Turn off the power, and then on.

ON LINE

E2-27