Toshiba B-852 Printer Setup, Setup Flow, Procedure, Reference, Manual threshold setting

2. PRINTER SETUP

ENGLISH VERSION EO1-33055

2. PRINTER SETUP

2. PRINTER SETUP

This section outlines the procedures to setup your printer prior to its operation. The section includes precautions, loading media and ribbon, connecting cables, setting the operating environment of the printer, and performing an online print test.

Setup Flow

Installation

Assembling the supply holder

frame

Connecting the power cord

Loading the media

Media sensor position

alignment

Loading the ribbon

Connecting to a host computer

Turning the power ON

Setting the operating

environment

Installing the printer driver

Print test

Position and Print Tone Fine

adjustment

Automatic threshold setting

Procedure

After referring to the Safety Precautions in this manual, install the printer on a safe and stable location.

Assemble the supply holder stand, and attach it to the rear of the printer.

Connect a power cord to the power inlet of the printer, then, to an AC outlet.

Load a label stock or tag stock.

Adjust the position of feed gap sensor or black mark sensor according to the media to be used.

In case of thermal transfer printing, load the ribbon.

Connect the printer to a host computer or a network.

Turn on the printer power.

Set the printer parameters in the system mode.

If necessary, install the printer driver in your host computer.

Make a print test in your operating environment and check the print result.

If necessary, fine adjust the print start position, cut/strip position, print tone, etc.

If the print start position cannot be detected properly when pre-printed label is used, set the threshold automatically.

Reference

2.1Installation

2.2Assembling the Supply Holder Frame

2.3Connecting the Power Cord

2.4Loading the Media

2.5Setting Sensor Positions

2.6Loading the Ribbon

2.7Connecting the Printer to Your Host Computer

2.8Turning the Printer

ON/OFF

2.9Setting an Operating Environment

2.10Installing the Printer Drivers

2.11Print Test

2.12Position and Print Tone Fine Adjustment

2.13Threshold Setting

Manual threshold setting

If the print start position cannot be detected	2.13 Threshold Setting
properly even an automatic threshold setting is
performing, manually set the threshold.

E2- 1