Toshiba B-852 owner manual Loading Media into the Printer

2. PRINTER SETUP

ENGLISH VERSION EO1-33055

2.4 Loading the Media

2.4.2Installing the Supply Holder Unit onto the Supply Holder Frame

NOTE:

Make sure that the brass bushings of the Supply Shaft are seated into the notches so that the entire Supply Holder Unit rotates smoothly.

1.Insert the assembled Supply Holder Unit into the rear notches of the Supply Holder Frame as shown in the diagram below.

Rear Notch

CAUTION!

The reassembled Supply Holder Unit and media roll may be quite heavy, so be careful not to pinch your fingers when installing the Supply Holder Unit onto the Supply Holder Frame.

2.4.3Loading Media into the Printer

WARNING!

The Top Cover can be opened during the operation for control purposes only. It should be closed during normal operation.

Supply Holder

Frame

Brass Bushing

2.Now feed the media from the bottom of the media roll into the media slot at the rear of the printer as shown.

The following paragraphs outlines how to properly install the media into the printer from the Supply Holder Unit that has been installed in the previous steps.

1.Raise the Top Cover as shown in the diagram below.

Top Cover

E2- 7