Toshiba B-852 owner manual IP Address Setting TCP/IP

2. PRINTER SETUP

ENGLISH VERSION EO1-33055

2.9 Setting an Operating Environment

2.9.7IP Address Setting (TCP/IP)

Power OFF

While holding down the [FEED] and [PAUSE] keys, turn on the printer.

<1>DIAG. Vx.x

[FEED] [RESTART]

<2>PARAMETER SET

[FEED] [RESTART]

<3>ADJUST SET

[FEED] [RESTART]

<4>TEST PRINT

[FEED] [RESTART]

<5>SENSOR ADJ.

[FEED] [RESTART]

<6>RAM CLEAR

[FEED]

[RESTART]

<7>IP ADDRESS

[FEED]

[RESTART]

<8>BASIC

[FEED]

[RESTART]

<9>FOR FACTORY

[FEED] [RESTART]

When the printer is connected to a PC through TCP/IP by using a LAN cable, it is necessary to set an IP address in the System Mode for system administrators.

The System Mode for system administrators consists of the following menus.

<1>DIAG. Vx.x	This menu is used to check and print the printer
	system information and maintenance counter
	status.
<2>PARAMETER SET	This menu is used to set the printer parameters.
<3>ADJUST SET	This menu is used to make a fine adjustment of a
	print start position, cut position, etc.
<4>TEST PRINT	This menu is used to perform print tests.
<5>SENSOR ADJ.	This menu is used to check the sensor statuses
	and adjust each sensor.
<6>RAM CLEAR	This menu is used to perform a RAM clear.
	DO NOT USE this menu.
<7>IP ADDRESS	This menu is used to set an IP address.
<8>BASIC	This menu is used to enable the printer to use
	Basic program.
<9>FOR FACTORY	This menu is intended for an in-process
	inspection. Do not use this menu.

E2-34