Toshiba B-852 owner manual Environment, How to enter the System Mode

2. PRINTER SETUP

ENGLISH VERSION EO1-33055

2.9 Setting an Operating Environment

2.9 Setting an Operating Depending on the settings of your host computer or an interface to be used, it may be necessary to change the printer parameter settings.

Environment

LCD Message Display

FEED key	PAUSE key
	RESTART key

Follow the procedures described below to change the printer parameter settings in the System Mode to correspond to your environment.

NOTE:

Incorrect settings can cause the printer to function erroneously. If you have any problems with the parameter settings, please contact your nearest TOSHIBA TEC service representative.

For the settings this manual does not cover, please contact your nearest TOSHIBA TEC service representative, or refer to the B-852 Series Key Operation Specification.

How to enter the System Mode

1.Turn on the printer and confirm that “ONLINE” appears on the LCD Message Display.

2.Press the [PAUSE] key to pause the printer.

3.Hold down the [RESTART] key for three seconds until “<1>RESET” is displayed.

ON LINE

[PAUSE]

PAUSE

Hold down [RESTART] for 3 sec.

<1>RESET

[FEED] [RESTART]

<2>PARAMETER SET

[FEED] [RESTART]

<3>ADJUST SET

[FEED] [RESTART]

<4>DUMP MODE

[FEED] [RESTART]

<5>EXPAND MODE

[FEED] [RESTART]

<6>AUTO CALIB

[FEED] [RESTART]

<7>LAN

[FEED] [RESTART]

<8>RTC SET

[FEED] [RESTART]

The System Mode consists of the following menus.

<1>RESET	This menu is used to clear print data sent from a
	PC and return the printer to an idle state.
	Refer to Section 3.3 Reset.
<2>PARAMETER SET	This menu is used to set the printer parameters.
	Refer to Section 2.9.1 Parameter Setting.
<3>ADJUST SET	This menu is used to make a fine adjustment of a
	print start position, cut position, etc.
	Refer to Section 2.12 Position and Print Tone
	Fine Adjustment.
<4>DUMP MODE	This menu is used to print the data in the receive
	buffer for debug.
	Refer to Section 2.9.2 Dump Mode Setting.
<5>EXPAND MODE	This menu is used to start the program for
	BASIC mode.
	Refer to Section 2.9.3 BASIC Expansion
	Mode.
<6>AUTO CALIB	This menu is used to enable or disable the
	automatic calibration function.
	Refer to Section 2.9.4 Automatic Caliburation.
<7>LAN	This menu is used to enable or disable the LAN
	communication and SNMP.
	Refer to Section 2.9.5 LAN Setting.
<8>RTC SET	This menu is used to set the date and time of the
	real time clock, enable or disable the low battery
	check, and choose a real time renewal timing.
	Refer to Section 2.9.6 Real Time Clock
	Setting.

NOTES:

1.System Mode menus can be selected with the [RESTART] or [FEED] key.

2.To enter each of the above System Mode menus, press the [PAUSE] key when the menu is displayed.

3.If the [PAUSE] key is pressed with “<1>RESET” being displayed, the printer will turn to an idle state and the message will change to “ONLINE”

E2-14