Toshiba GD-1260, GD-1250, GD-1270 manual ‰ Placing the originals on the Radf

2 SENDING/RECEIVING A FAX

‰Placing the original(s) on the RADF

This section describes how to set the original(s) on the RADF (Reversing Automatic Document Feeder, optional). When the originals are placed on the RADF, the uppermost page is the first to be scanned and sent.

The RADF is an optional unit for the e-STUDIO4520C Series / e-STUDIO455 Series. It is equipped with the e-STUDIO6530C Series / e-STUDIO855 Series as a standard.

1 After aligning the originals, place them with their face up and slide the guides to rest against the edges of the originals.

yRegardless of their sizes, originals are acceptable up to 100 sheets (35 to 80 g/m2 (9.3 to 20 lb.)) or 16 mm (0.62") in height.

y2-sided originals can be set and sent.

P.54 “Transmitting 2-Sided Originals”

A

B

yWhen an original of any size other than LT/A4 is placed in the direction shown in the above left figure, transmission to a recipient is carried out so that the pre-entered sender information is printed in position A in the figure.

yWhen an original of LT/A4 size is placed in the direction shown in the above right figure, transmission to a recipient is carried out so that the pre-entered sender information is printed in position B in the figure.

yThe pre-entered sender information shows what is registered in the Terminal ID.

P.103 “Registering the terminal ID”

Sending a Fax 25