Toshiba GD-1260, GD-1250, GD-1270 manual TX Type, Exposure, Tti, Rti, Ecm

6 SETTING ITEMS

TX TYPE

Set the fax transmission mode.

MEMORY TX:	Send the original after the scanned data are saved in the memory. Up to 100 transmissions can
	be reserved. Up to 1000 pages can be sent in one transmission.
DIRECT TX:	Send the original directly as it is being scanned. Once a page has been scanned and sent, the
	next page is scanned and sent. Therefore, it takes longer to scan and send all pages. However,
	you can confirm on the fly that each page is sent to the recipient.

EXPOSURE

Set the density at which the original is to be scanned.

AUTO:	This equipment automatically detects the contrast of the original, and scans it with the optimum
	contrast.
MANUAL:	Press	or	to set the desired contrast.

TTI

Switch the TTI recording ON or OFF. To enable this feature, the Terminal ID must be registered to this equipment in advance.

P.103 “Registering the terminal ID”

Setting this item may not be required since it may not be displayed on the screen (it depends on your country or region).

RTI

Switch the RTI recording ON or OFF. To enable this feature, the Terminal ID must be registered to this equipment in advance.

P.103 “Registering the terminal ID”

ECM

Switch the ECM (Error Correction Mode) communication ON or OFF.

ECM is an internationally standardized communication mode that automatically corrects errors that occur during fax transmissions. With this setting option ON, even when the transmitted data have been affected by noise during communication, this mode allows good communication without image distortion by automatically resending the part that have been affected.

yBoth the sender and the receiver must have the ECM function to make ECM communication available.

yWhen affected by noise during communication, communication time is slightly longer than usual. Even when the ECM communication is used, an error may occur depending on the line status.

yThe ECM communication is not available for voice communication.

100 User Settings