2 SENDING/RECEIVING A FAX

„Originals and paper

‰Acceptable size of paper

A3, B4, A4, B5, A5, FOLIO, LD, LG, LT, ST and COMP sized paper are available.

The printing range of each size of paper is as follows: As shown in the figures below, if an original document contains any information in the shaded area, it is not printed on the paper.

5 mm

 

5 mm

 

(0.2 inch)

 

(0.2 inch)

5mm (0.2 inch)

5 mm

5 mm

 

 

5 mm

(0.2 inch)

(0.2 inch)

 

 

 

 

 

 

 

 

(0.2 inch)

 

 

 

 

 

 

 

 

 

5 mm

5 mm

 

 

(0.2 inch)

(0.2 inch)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ySet the paper in the drawers or the Large Capacity Feeder (optional). The bypass tray is not available.

yRegardless of whether or not the Finisher (optional) is installed, paper exits on the receiving tray.

yDrawers can be set for fax use only. For details of the operation, refer to the Copying Guide.

‰Default setting for RX printing

To print the received fax, the paper with the same width as the original is used. Depending on the length of the original, “RX reduction printing” or “Discard printing” (both of them are set to ON by manufacture default) are applied.

P.106 “Setting RX printing”

When an original is shorter or the same as the paper printing area

It is printed in the original size.

When an original is longer than the paper printing area

It is printed according to the following priority:

yWhen an original is up to 10 mm (0.4 inch) longer than the printing area: the part of the originals that exceeds the paper printing area is discarded.

yWhen an original exceeds the printing area by more than 10 mm (0.4 inch): the original image is reduced to 75 % (reduction printing). If the image still cannot be fitted into the printing area, paper larger than the original is selected. In case there is no larger paper available, the original is printed with the image divided.

42 Receiving a Fax

Page 44
Image 44
Toshiba GD-1270, GD-1260, GD-1250 manual „ Originals and paper ‰ Acceptable size of paper, ‰ Default setting for RX printing