Toshiba MA-600-1 owner manual Dollar Discount, Percent Discount, Percent Charge, AmountDOLL Disc

11. REGISTERING PROCEDURE AND PRINT FORMAT EO1-11155

11.28 Dollar Discount

11.28 Dollar Discount

OPERATION
- - -	Dept or PLU item entry

(for discount from an individual item)

- - - [ST]

(for discount from the sale total)

Amount[DOLL DISC] - - -

-- Receipt Print Format --

(for discount from an individual item) (for discount from the sale total)

DP01	$1.00
DISC	-0.05

SUBTL	$21.00
DISC	-1.00

NOTES:

1.This operation can be performed both inside a sale and outside a sale. (The “credit balance” option is ignored.) The dollar discount amount exceeding the subtotal amount can be entered.

For the department or PLU programmed with taxable or food stampable status, the amount exceeding each subtotal amount can also be entered.

When the taxable or food stampable amount is negative, the Dollar Discount operation is performed on it.

2.When the discount amount limit has been programmed, the Dollar Discount operation on the discount amount

exceeding the limit is not possible in REG mode. As the discount amount limit is not effective in MGR and modes, the Dollar Discount operation on a maximum of 7-digit discount amount is possible.

3.After performing a dollar discount operation, neither the Dollar Discount operation nor the Percent Charge/Discount operation is possible.

-

11.29 Percent Discount, Percent Charge

OPERATION

Dept or PLU entry

Positive Previous Balance entry (credit balance)

[ST]

[%-](or [%+])	for the preset rate
Rate [%-](or [%+])	for the manual rate

-- Receipt Print Format --

DP03	$3.40
%-
5%	-0.17

SUBTL	$6.00
%-
10%	-0.60

NOTES:
1. Rate	0.001 to 99.999 (%).

2.When no rate is preset, the value of rate should be entered.

3.When the Dept or PLU item entry is modified with [RTN MDSE] or [VOID], the following % entry will also be modified with [RTN MDSE] or [VOID].

4.A % entry will cause an error if operated after a Negative Department/PLU or [TXBL TL].

5.Even when the rate is preset, an inputted numeric value will be activated as a rate. (Entry of the numeric value 0 causes an error.)

6.A % entry after obtaining a subtotal is usually allowed only once. However, it can be programmed to allow multiple times. (Ask your TOSHIBA TEC representative.)

11-23