Toshiba MA-600-1 owner manual Condition Required for Programming Operations

4. PROGRAMMING OPERATIONS EO1-11155

4.1 Instructions for Programming

4.1.3Condition Required for Programming Operations

“CONDITION” is given at the top of each programming operation. The ECR must satisfy this condition to perform programming operations.

There are two types of conditions:

“Any time outside a sale”

It means that the programming operation is allowed when a sale is finalized before going into any other sale entry.

“After------ reset”

It means that the designated reset report must be taken before entering the programming operation.

And an error will result if the operation is attempted without taking the report. However, the words “After ...

Reset” do not necessarily mean “immediately after ...”.

When the designated reset report has already been taken and then some operations are performed in the SET, X, or Z mode, the condition “After ... Reset” is still satisfied and the programming operation is still allowed.

On the contrary, when the designated reset report has been taken but then some sales data relating to that report’s output data are entered in the REG, MGR, or - mode, the programming operation will no longer be allowed and the same reset report must be taken.

Thus the condition “After ... Reset” indicates that all the sales data relating to the report data must be zero (except non-resettable memory data). Because of this “CONDITION” requirement, the report data will be protected from any inconsistencies of sales data entered in the period from a resetting of the report to another resetting of the same report next time.

Programming operation	Required condition
Time Setting or Adjustment	Any time outside a sale
Date Setting or Adjustment	Any time outside a sale
Store Name Message Programming	Any time outside a sale
Commercial Message Programming	Any time outside a sale
Footer Message Programming	Any time outside a sale
Cashier Name and Status Programming	Any time outside a sale
Department Table Programming	To change the positive/negative status:
	After Department and PLU Daily and GT Resets
	To change any other programmed data or to newly
	program departments:
	Any time outside a sale
Department Name Programming	Any time outside a sale
Department Group Name Programming	Any time outside a sale
PLU Table Programming	Any time outside a sale
PLU Name Programming	Any time outside a sale
Department Preset Price Setting or Changing	Any time outside a sale
PLU Preset Price Setting or Changing	Any time outside a sale
Tax Table Programming	After Financial Daily Reset
%+ and %- Preset Rate Setting	Any time outside a sale
Foreign Currency Exchange Rate Setting	Any time outside a sale

4- 5