Toshiba MR-3018 service manual Spring

[D] Original feed motor (M1)

(1)Take off the rear cover.

( P.4-2 "[B] Rear cover")

(2)Disconnect 1 connector. Then remove 2 screws to take off the original feed motor.

[E]Original feed motor drive section

(1)Take off the rear cover.

( P.4-2 "[B] Rear cover")

(2)Disconnect 1 connector, and then remove 1 spring. (Spring: Outside diameter of coil – ø9.6 mm, acceptable turns of coil – 12 turns)

(3)Remove 3 screws, and then take off the orig- inal feed motor with its bracket.

Note:

When the unit is being assembled, tempo- rarily tighten the screws removed at step (3) and then attach the spring removed at step

(2). Then fully tighten these screws.

Connector

Original feed motor

Fig.4-57

Connector

Spring

Fig.4-58

Original feed motor

Fig.4-59

4

June 2005 © TOSHIBA TEC MR-3018 DISASSEMBLY AND ASSEMBLY

4 - 21