Toshiba MR-3018 service manual Spring

[C] Read motor drive section

(1)Take off the rear cover.

( P.4-2 "[B] Rear cover")

(2)Take off the fan motor.

( P.4-18 "[A] Fan motor (M4)")

(3)Disconnect 1 connector, and then remove 1 spring. (Spring: Outside diameter of coil – ø10.2 mm, active coils – 12.5)

(4)Remove 3 screws, and then take off the read motor with its bracket.

Note:

When the unit is being assembled, tempo- rarily tighten the screws removed at step (3), and then attach the spring removed at step

(2). Then fully tighten these screws.

(5)Remove 1 spring. (Spring: Outside diameter of coil –ø8.8 mm, active coils – 12.5)

(6)Release the harness from 2 harness clamps.

Connector

Spring

Fig.4-51

Read motor
Screw
	Fig.4-52
Harness clamp	Harness clamp

Spring

Fig.4-53

4

June 2005 © TOSHIBA TEC MR-3018 DISASSEMBLY AND ASSEMBLY

4 - 19