Toshiba MR-3018 service manual Adjustment of the Leading Edge Position, Chart Original

5.4Adjustment of the Leading Edge Position

Note:

Check if the image adjustment for the equipment is performed properly before this adjustment of the RADF. (See the Service Handbook of applicable equipment.) Also, the RADF position and height shall be adjusted properly.

[A]Checking

Check the image using the chart (original) with vertical and horizontal lines in the following procedure.

Simplex copying:

(1)Place the chart provided as an original with its face up on the original tray of the RADF, select [1 Sided -> 1 Sided] and press the [START] button.

(2)Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.

Duplex copying:

(1)Place the chart provided as an original with its face up on the original tray of the RADF, select [2 Sided -> 2 Sided] and press the [START] button.

(2)Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.

E	F
	5

Fig.5-24 Chart (Original)

[B]Adjustment

Simplex copying:

Fig.5-25 Copy

(1)Turn the power ON while pressing [0] and [5] simultaneously, key in [365] and then press the [START] button.

(2)Enter the value.

•If the leading edge (F) margin of the copy image is larger than the (E) margin of the chart, enter a value smaller than the current one.

Note:

Changing one value shifts the copy image by 0.1 mm.

•If the leading edge (F) margin of the copy image is smaller than the (E) margin of the chart, enter a value larger than the current one.

Note:

Changing one value shifts the copy image by 0.1 mm.

(3)Press the [ENTER] button.

June 2005 © TOSHIBA TEC MR-3018 Adjustment

5 - 11