Toshiba MR-3018 service manual Registration roller Take off the feeder lower guide

[F]	Registration roller
(1)	Take off the feeder lower guide.
		Bushing	E-ring	Registration roller
	( P.4-10 "[E] Feeder lower guide")
(2)			Pulley Bushing
	Take off the original feed motor drive section.

	(	P.4-21 "[E] Original feed motor drive sec-
	tion")
(3) Remove 1 E-ring and 1 bushing from the
	front side of the registration roller shaft. Also,
	remove 1 bushing, 1 pulley, 1 E-ring and 1			Bushing
	bushing from the rear side of the shaft, and
	then take off the registration roller.			E-ring
			Fig.4-29
[G]	Exit/reverse roller
(1) Take off the front cover.			Bushing	Pin
	(	P.4-1 "[A] Front cover")
(2) Take off the original exit/reverse motor.
	(	P.4-23 "[F] Original exit/reverse motor
	(M3)")
(3) Remove 1 clip, 1 pulley, 1 pin and 1 bushing				Pulley
	from the rear side of the exit/reverse roller
	shaft.			Clip
			Fig.4-30

4

(4)Remove 1 screw and take off the leaf spring.

(5)Remove 1 clip and 1 bushing from the front side of the exit/reverse roller shaft.

Leaf spring

Bushing Clip

Fig.4-31

June 2005 © TOSHIBA TEC MR-3018 DISASSEMBLY AND ASSEMBLY

4 - 11