Tyco installation manual Chapter Installing 4100U FACP Components, Topic, See Page #

Introduction

In this Chapter

Chapter 2

Installing 4100U FACP Components

4100U cabinets are available in one-, two-, and three-bay sizes. Each can be equipped with a solid or perspex door. This chapter describes how to mount all types of 4100U cabinets to a wall, and how to mount system card bays into the cabinets, modules to bays, etc.

FACPs are assembled to order within the factory. Steps 2 to 6 below are therefore not typically required in the field, but are included in case of in-field system expansion.

The section Introduction to FACPs describes the various components that make up the FACP.

The assembly drawings 1976-136, 1976-137 are included in the appendix of this manual for reference.

Refer to the page number listed in this table for information on a specific topic.

	Topic	See Page #
Introduction to FACPs (4100U)		2-2
Step 1. Mounting Cabinets (4100U)		2-9
Step 2. Mounting Card Bays to Cabinets (4100U)		2-9
Step 3. Configuring Cards (4100U)		2-10
Step 4.	Interconnecting Modules and Bays	2-11
		2-15
Step 5.	Installing Modules into Expansion Bays (4100U)
Step 6.	Installing LED/Switch Modules into Expansion Bays	2-20
(4100U)
The Terminal Block Utility Module (4100U)		2-27

2-1