Tyco installation manual TIC/Riser Mounting 4100U, 2.TIC Mounting, Continued on next page

TIC/Riser Mounting (4100U)

Overview

Mounting Instructions

All TICs are mounted like any 4-inch (102 mm) X 5-inch (127 mm) card. This section describes the TIC/audio riser card mounting procedure, which is identical to that of other 4-inch (102 mm) X 5-inch (127 mm) cards.

Use the following instructions and Figure 4-2, below, to mount 4”x 5” slave cards to an expansion cabinet.

IMPORTANT:

•The TIC must be mounted in the upper left position of the bay.

•The audio riser card must be mounted directly below the TIC.

1.Screw two standoffs and washers to the appropriate holes in the back of the cabinet. These holes must line up with the screwholes in the 4-inch (102 mm) X 5-inch (127 mm) card. See Figure 5-2.

2.Plug the 4-inch (102 mm) X 5-inch (127 mm) card into the top left PDI connector (P8).

3.Secure the top of the card to the standoffs with two #6 torx screws and washers.

WASHERS

SCREW STANDOFFS

RETAINERS

TIC CARD

#6 SCREWS

PDI CONNECTOR	PDI
(reverse side)

Figure 4-2. TIC Mounting

Continued on next page

4-9