Tyco 4100U installation manual Local mode is supported by the following, Continued on next page

Introduction to MINIPLEX Transponders (4100U), Continued

Local Mode Specifications

Local mode is supported by the following:

•4100-3101/3104/3105 IDNet Card

•4100-5101/5102/5103 Expansion Power Supply NACs (including TrueAlert Non-Addressable SmartSync appliances)

•4100-5111/5112/5113 System Power Supply NACs (including TrueAlert Non- Addressable SmartSync appliances)

•4100-5125/5126/5127 Remote Power Supply NACs (including TrueAlert Non- Addressable SmartSync appliances)

•4100-5120/5121/5122 TrueAlert Power Supply NACs

•4100-1214 to -1225, 4100-1228 to –1239, 4100-1314 to -1325, 4100-1328 to – 1339,

100 W Amplifier NACs

•4100-1212/1213/1226/1227/1312/1313/1326/1327 Flex 50 Amplifier NACs

•4009-9401 TrueAlert Addressable Controller

•4100-1270 Phone Controller and 4100-1272/1273 Phone NAC cards

•4009-9201/ 9301 IDNet NAC Extender

•4100-5116 Expansion Signal Card

Local mode is NOT supported by, but can co-exist with, the following:

•4100 Legacy cards

•4100-3101 to -3103 Auxiliary Relay Cards

•4100-6048 VESDA Interface Kit

•4100-6043/6044 RS-232/2120 Interfaces

•4100-1280 to -1287 LED/Switch Annunciators

•4100-1290 24-Point Graphic I/O Module

•4602-9101 SCU/ 4602-9102 RCU

•4603-9101 LCD Annunciator

•4100-1210/1211/1311 Audio Controller Board

•4100-6014 Network Interface Card

•4100-6052 DACT

Bear in mind the following limitations for when local mode is in effect:

•If an alarm is already activated when local mode is initiated, the alarm remains activated in local mode.

•Software zones are not supported. Basic TrueAlert channels are supported.

•Alarm verification is not supported. All alarms are reported immediately.

•SMPL is not supported.

•TrueAlarm sensors have fixed thresholds.

Continued on next page

4-5