Tyco 4100U Wiring Network Cards, Continued, 12.Wired Media, Style 7 Wiring, Notes

Step 4. Wiring Network Cards, Continued

Wiring Illustrations

Wired Media,

Style 7 Wiring

The figures below show how to wire the NIC. The illustrations use the 565-274 and 565- 275 motherboards only. If you are using the 4100U motherboard, refer to Figure 5-11 along with the figures below.

SEE NOTE 3 SEE NOTE 3

Notes:

1. Refer to general wiring precautions in this chapter, as well as Field Wiring Specifications: document 900-082 for 4100; 900-242 for 4100U.

2. When the 565-413 Interface Card is used with 565-516, -407, or –409 Network Card, TB1 on the 565-413 Interface Card cannot be used. Connection to the motherboard is required as shown.

3. The shield should only be connected at one end of the line. The shield is connected to the left port.

4. On assembly 565-274, JW1 and JW2 must be installed. Jumper plugs must not be installed on P5-P8.

SEE NOTE 5

5. Each “wired” media cable requires two ferrite beads, one at each end (included in the shipping group). Refer to installation instructions 574-041 for proper bead mounting.

Figure 5-12. Wired Media, Style 7 Wiring

Continued on next page

5-17