Tyco 4100U installation manual directly

Step 5. Installing Modules into Expansion Bays (4100U), Continued

Installing Motherboards

Use the following procedure when installing motherboards in an expansion bay. Start with the second slot from the left and fill to the right. The mounting items are available as KT0468.

1.Orient the motherboard with the connector labeled J1 on the right and the header labeled P1 on the left.

2.Attach four metal threaded standoffs and lockwashers into the screw holes on the chassis.

3.Attach two grey plastic standoffs to the motherboard socket mounting screws.

4.Secure the motherboard to the standoffs using four #6 torx screws as shown below.

WARNING:	Note that a 4100 Motherboard with daughter card cannot be fitted
directly		behind a 64/64 LED/Switch Controller. The same applies
to the modules made		on the bay mounting bracket (FA2255), e.g.

ME0426 T-Gen.

METAL
STANDOFFS	SCREW HOLES

PLASTIC STANDOFFS

#6 SCREWS

SCREW HOLES

LOCKWASHERS

Figure 2-13. Installing the Motherboard in a 4100U Expansion Bay

2-19