Tyco 4100U Wiring Network Cards, Continued, The illustration below shows coupler wiring

Step 4. Wiring Network Cards, Continued

4190-9010 Coupler	The illustration below shows coupler wiring.
Requirements
(continued)

	Figure 5-10. Coupler Wiring
Wiring with the
	Refer to the guidelines and figures in this topic to use wired media cards.
Wired Media Card
	IMPORTANT: TB1 on the wired media card must not be used when it is
	connected to the 4100-6014 NIC.
	• When the 565-413 Interface Card is used with 565-516, -407, or –409 Network
	Card, TB1 on the 565-413 Interface Card cannot be used. Connection to the
	motherboard is required as shown.
	• The shield should only be connected at one end of the line. The shield is
	connected to the left port.
	• When wiring leaves the building, 2081-9044 Overvoltage Protectors are
	required. One overvoltage protector is installed where wiring leaves the building;
	another is installed where wiring enters the next building.
	Continued on next page

5-15