Vax M-9000 Emergency indicator, Unit indicator, Fault indicator, Input meter status indicator

[VFD on-screen indications]
								15			16	17					18	19
																	d B
																	k Hz
																	m sec
		COM					GAIN		d B		Q					FREQ
		FAULT	1	2	3	4	5	6	7	8	KEYLOCK		1	2	3	4
											EMERGENCY		5	6	7	8
		FADER	OL													OL	FADER
			0								TONE	GATE				0
			–10								LOUD	DUCK				–10
			–20													–20
											EQ	NOM
		LEVEL	–30													–30	LEVEL
											COMP	DELAY
			–40													–40
20	21	22	23				26				27				30	31	32
					3								5
				24		25						28		29

15.14-Segment,18-digit alphanumeric display Displays the corresponding setting screen or data when each function key is pressed. Parameters being edited flash.

16.Keylock indicator

Lights when the key lock function is enabled, and flashes while the key lock function is being edited.

17.Emergency indicator

Lights when the control input set for "Emergency mute" becomes active.

18.Unit indicator

Displays the unit of each parameter when it is set.

19.GAIN, dB, Q, FREQ indicators Lights when the equalizer is adjusted.

20.COM indicator

Remains lit during communications via the RS- 232C interface.

21.Fault indicator

Lights when the unit's failure or other abnormal conditions are detected.

(Refer to p. 118 "ERROR INDICATIONS.")

22.Input meter status indicator

Indicates which the input level (LEVEL) or input fader position (FADER) is being displayed on the input meter (26).

Note

Input level is displayed only when the D-001T module is used.

23.Input level indication

Scale of levels (in dB) for the input meter.

24.Input channel selection indicator (red dot) Lights when the corresponding input channel is selected, and flashes while parameters are being edited.

25.Input channel ON/OFF indicator (channel number)

The indicators for all channels normally light regardless of whether or not the channels can be selected by the input channel selection keys (2) or can be used (p. 120 "Remarks"), while they flash when turned off by the input channel ON/OFF key (5).

The indicators of unused channels can be set to be off in the Utility setting item.

26.Input meter

Indicates the signal level or input fader position of each input channel.

Which the meter is indicating is displayed on the input meter status indicator (22).

Notes

•The input meter is kept on even for the channel that is turned off or muted.

•Input level is displayed only when the D-001T module is used.

27.Effect indicator

Lights when effect is on, and flashes while the parameters are being edited.

13