ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS
3.Release the clips on the back of the mounting rail.
4.Reverse procedure to install.
BLOWER AND MOTOR
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
Removal
1.Remove the rack guide, filter and exhaust assembly as outlined under “RACK GUIDE/ FILTER/EXHAUST ASSEMBLY”.
2.Loosen bolt (one turn) that secures the blower and install puller.
3.Tighten the puller, then tap the puller with a hammer to loosen the blower from the motor shaft.
4.Remove the puller, bolt, washer and blower from the motor shaft.
NOTE: If only the blower is being removed, reverse the procedure at this point to install.
5.Remove the rear panel as outlined under
“COVERS AND PANELS”.
6.Disconnect the lead wires from the motor.
7.Remove the motor from the back of the oven by removing the mounting nuts.
8.Remove the cover plate and seal from inside the oven cavity.
NOTE: You may have to drive the seal out from the back of the oven.
Page 12 of 68
