ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS
DOOR MAGNETIC REED SWITCH
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
1.Remove the right side panel as outlined under
“COVERS AND PANELS”.
2.Remove the nuts that secure the door switch mounting bracket to the bottom of the control panel. On 20 levels, the switch is mounted to the underside of the channel for the door handle (no bracket required).
3.Disconnect the switch lead wires.
4.Remove the switch from the oven.
6 AND 10 LEVELS
5.Reverse procedure to install and check for proper operation.
DOOR SEAL
1.Turn the oven off.
2.Open the oven door.
3.Remove seal from the edge of the inside glass.
4.Clean the edge of the glass, remove the old adhesive.
5.Apply red silicone to the replacement seal and install the seal to the glass edge. The vent holes must be installed to the outside to allow the seal to contract when the door is closed.
6.Adjust door closure, if necessary, as outlined under “OVEN DOOR AND DOOR LOCK ADJUSTMENT” in “SERVICE PROCEDURES AND ADJUSTMENTS”.
DOOR LOCKING MECHANISM
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
Replacement
1.Remove the right side panel as outlined under
“COVERS AND PANELS”.
2.Disconnect the lead wires to the motor and switches.
3.Remove the nuts from the mounting studs and remove the assembly from the oven.
Page 20 of 68
