ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS
4.Remove the spring and positioning plate from the locking arm.
5.Reverse procedure to install and adjust as outlined under “OVEN DOOR ADJUSTMENT” in “SERVICE PROCEDURES AND ADJUSTMENTS”.
Disassembly
1.Remove the three screws that secure the motor and switch assembly.
2.Remove the motor, gear box and switch assembly from the locking mechanism. Remove the two bolts from the locking mechanism. The springs, locking arm and bushings can be removed.
4.The springs, locking arm and bushings can be removed.
5.Reverse procedure to install.
OVEN CAVITY SEAL
1.Open the door.
2.Pull the seal from the groove around the oven cavity.
3.Push the arrow head tip of the gasket into the groove. Install the four corners first.
4.Start at the corners and work to the middle of each side, being careful not to stretch the replacement gasket.
5. Check the door for proper operation and adjust if necessary, as outlined under “OVEN DOOR AND DOOR LOCK ADJUSTMENT” in
“SERVICE PROCEDURES AND ADJUSTMENTS”.
3.Remove the two bolts from the locking mechanism.
Page 21 of 68
