ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS
OVEN DOOR
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
Removal
1.Remove the left and right side panels as outlined under “COVERS AND PANELS”.
2.Disconnect the lead wires to the lamp on the power supply board terminal block and route them so they can be pulled through the hole in the frame when the door is removed.
3.Support the door, remove the screws from each hinge block on the oven and remove door.
4.Reverse procedure to install.
Disassembly
1.Remove the door from the oven as outlined above in “REMOVAL”.
2.Lay the door on a flat surface with the inside of the door facing up.
3.Lift up along the inner door glass edge near the door latch and unsnap the glass from the “snap catches” in the oven door.
4.Open the inner door glass and remove the c- ring clamps from the rear snap catches, unsnap at the rear then lift off.
CAUTION: When replacing the inner door glass, it must be installed with the conductive side toward the front of the oven. Use an ohmmeter to verify the conductive side. Set the meter to read ohms and touch glass with the meter leads. A resistance will be measured but will vary depending on the distance between the meter leads, grease and/or other substances on the glass.
5.Remove the bolts securing the top and bottom hinges to the door.
6.Remove the drip tray, remaining screws from the inner door panel, the screws at the left, right and bottom of the door and remove the door handle.
7.Lift the inner door panel from the outer door frame.
8.Remove the outer door glass.
9.Reverse procedure to install.
10.Adjust the door as outlined under “OVEN DOOR ADJUSTMENT” in “SERVICE PROCEDURES AND ADJUSTMENTS”.
Page 18 of 68
