Doors | Wayne-Dalton 341458 instruction

9800 doors

TorqueMaster® Plus - Single and Double Spring

Installation Instructions and Owner’s Manual

Wayne-Dalton, a Division of Overhead Door Corporation P.O. Box 67, Mt. Hope, OH 44660 www.Wayne-Dalton.com

IMPORTANT NOTICE!

Read these instructions carefully before attempting installation. If in question about any of the proce- dures, do not perform the work. Instead, have a qualified door agency do the installation or repairs.

©Copyright 2010 Wayne-Dalton, a Division of Overhead Door Corporation

Part No. 341458

REV2 02/26/2010

Image 1

Wayne-Dalton 341458 installation instructions Doors, Important Notice

Contents

Important Notice Doors Table of Contents Package Contents Door Section Identification Tools Required For Standard Lift Torsion Spring RemovalFailure to use approved Winding bars can cause Spring energy to be released Unwind Springs Removal TorqueMaster SpringBracket and Drive Gear Removing the Old Door Extension Spring Removal Preparing the Opening Attaching Quick Install Flag Angle to Vertical Track InstallationTools Needed None Flagangle Horizontal Angle Installed as shownTools Needed Place tabs of horizontal angle Brackets Installing Fully Adjustable Jamb Drums Installing Q.I. Jamb Brackets Vertical Track Bottom Section Top Brackets Stacking Sections Properly Operator Bracket Top Section Attaching Horizontal Track To Quick Install FlagangleDo not Raise Door Until Injury Severe or Fatal Injury Center Bracket Bushing TorqueMaster Spring Tube Cable Drums Drum WrapsGarage Looking OUT End Brackets Tools Needed Power Drill Socket Driver Wrench 16 18 x 3/4 Securing Center Bracket AssemblyRight End Bracket 16 x 1-5/8 Securing Door For Spring Winding Cable Adjustment Recommended Spring Turns Winding Springs Tools Needed To install drum wraps, position the left Drum Wrap InstallationHand drum wrap over the left hand Raising door further can Rear SupportResult in door falling Otherwise door could fall Full Tension of the Spring Spring Turn Chart Company Reset the System TorqueMaster Plus Reset InstructionsResetting the ANTI-DROP Device While the Door is Moving Balancing Door Steps to reset the systemPawl TorqueMaster Plus Reset Side Lock Tools Needed Power Drill Drill BitPull Rope Pull Rope Bottom Bracket Failure to Make Adjustments Or REPAIRS, if NECESSARY, can Immediate adjustments or repairsInstall operator rail 1/2 to Trolley Operator Glass Cleaning Instructions Cleaning Your Steel And Fiberglass Garage DoorAcrylic Cleaning Instructions Important do not USE a Pressure Washer on Garage Door Fiberglass Refinishing And Or Finishing Steel Preparation For Painting Lifetime Limited Warranty Model Thank you for your purchase