Wayne-Dalton 341458 Installation, Attaching Quick Install Flag, Angle to Vertical Track

Installation

IMPORTANT: Read instructions titled “p4” “Removing the old door” on page 9 and “p5” “PREPARING THE OPENING” on page 10 before attempting door installation.

IMPORTANT: Stainless steel or PT2000 coated lag screws MUST be used when installing center bearing brackets, end brackets, jamb brackets, operator mounting/support brackets and disconnect brackets on treated lumber (preservative-treated). Stainless steel lag screws are NOT necessary when installing products on un-treated lumber.

NOTE: It is recommended that 5/16” x 1-5/8” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and 1/4” x 1-1/2” lag screws be pilot drilled using a 1/8” drill bit, prior to fastening.

INSTALLATION

1

Tools Needed:

None

Attaching Quick Install Flag

Angle to Vertical Track

NOTE: If you have fully adjustable flagangle, skip this step and complete Step 2.

Place the lower quick install tab of the flagangle in the quick install feature of the vertical track. Give the flagangle 1/4 turn to lock in place. Repeat for other side.

NOTE: After completing this step, continue with Step 3.

QUICK INSTALL TAB UNLOCKED QUICK INSTALL TAB LOCKED

FLAGANGLE

FLAGANGLE

VERTICAL	VERTICAL
TRACK	TRACK

Left hand track and flagangle Right hand track and flagangle

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 11 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com