Wayne-Dalton 341458 TorqueMaster Spring Tube, Center Bracket Bushing, Installation

	TorqueMaster® Spring Tube
Tools Needed:	TorqueMaster® springs come lubricated
None	and pre-assembled inside the
	TorqueMaster® spring tube. To install, lay
	the TorqueMaster® spring tube on the
	floor (inside garage) in front of the door
	with the labeled end to the left.

			TorqueMaster®	INSTALLATION
			Spring Tube
		LABELED END
17	Center Bracket Bushing			CENTER
				BRACKET
				ASSEMBLY

Tools Needed:	NOTE: If you are installing the idrive®
None	opener with your garage door, skip this
	step and go to your idrive® Installation
	Instruction/Owner’s Manual. After
	completing Steps 1 thru 10 in your
	idrive® Installation Instruction/Owner’s	TorqueMaster®
	Manual, continue with Step 22 of the	Spring Tube
	door Installation Instruction/Owner’s
	Manual.
	NOTE: If you are not installing an idrive®
	opener with your garage door, you
	must install the center bracket bushing	TorqueMaster®
	assembly. Continue to follow these	Spring Tube
	instructions for non-idrive®operated
	garage doors.
	Being cam shaped the center bracket
	bushing only fits one way.
	Slide the center bracket assembly
	towards the center of the TorqueMaster®	CENTER
	spring tube, from the right side as
		BRACKET
	shown.	BUSHING

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 21 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com