Tools Needed:

Winding Springs Continued...

To wind the spring, rotate the winding shaft clockwise, while watching the mark on the

Back of torquemaster® plus end bracket warning tag(s)

winding shaft. Rotate the winding shaft to the required number of turns for your door. Then return to the right hand side and wind the right hand spring to the required number of turns. Place pawl knob in lower position on both sides.

IMPORTANT: Mark number of spring turns on TorqueMaster® Plus end bracket warning tag(s).

NOTE: Since total turns to balance door can deviate from spring turn chart values by ± 1/2 turn, adjustments to the recommended number of turns may be required after rear hangers assembly is completed.

IMPORTANT! Hold the door down to prevent it from rising unexpectedly in the event the spring was overwound and cautiously remove vice clamps from vertical tracks. IMPORTANT! Adjustments to the recommended number of turns may be required. If door raises off the floor under spring tension alone, then reduce spring tension until door rest on the floor. If the door is hard to raise or drifts down on its own, then add spring tension.

Spring Turns

Door Height

Spring Turns

(6’ - 0”)

14

(6’ - 3”)

14 - 1/2

(6’ - 5”)

15

(6’ - 6”)

15

(6’ - 8”)

15 - 1/2

(6’ - 9”)

15 - 1/2

(7’ - 0”)

16

(7’ - 3”)

16 - 1/2

(7’ - 6”)

17

(7’ - 9”)

17 - 1/2

(8’ - 0”)

18

Number of Installed Spring Turns

Location for

marking number

of installed spring turns

INSTALLATION

25

Drum Wrap Installation

Drum wrap

 

(left hand)

 

 

 

 

Tools Needed:

To install drum wraps, position the left

Drum

 

None

hand drum wrap over the left hand

 

(left hand)

 

drum, align with counterbalance cable;

 

 

 

 

 

slide groove in drum wrap towards the

 

 

 

left until tabs snap over drum in

 

 

 

between drum and ratchet gear. Repeat

 

 

 

for right hand side.

 

 

 

IMPORTANT: Right and Left hand

 

 

 

are always determined from inside

 

 

 

the Garage looking out.

 

 

 

 

Counterbalance

 

 

 

cable

 

 

 

Tabs

 

 

 

Groove

 

 

 

in drum

 

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

27

 

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

 

Page 27
Image 27
Wayne-Dalton 341458 installation instructions Drum Wrap Installation, Tools Needed To install drum wraps, position the left