22
Tools Needed:
Vice Clamps
Securing Door
for Spring Winding
Place vice clamps onto both vertical tracks just above the third roller. This is to prevent the garage door from raising while winding counterbalance springs.
WARNING
Failure to place vice clamps onto vertical Track can allow door to raise and cause severe or fatal injury.
NOTE: Four section, 8’0” high
door is shown.
Place vice
clamps above
3rd Roller
Vice clamps
attached to 
Track track
INSTALLATION
23
Tools Needed:
Pliers/Wire
Cutters
Flat Tip
Screwdriver
Cable Adjustment
Starting on the right side, adjust the cable drum assembly by rotating the drum until the set screw faces directly away from the header. Loosen the set screw no more than 1/2 turn.
Pull on the end of the cable to remove all cable slack. Check to ensure the cable is aligned and seated in the first groove of the cable drum. Snug the set screw, and then tighten an additional
First Groove
Set Screw | Use these | WAR |
| this label | Rachet Brac |
|
| |
|
| EXTREME |
|
| TENS |
|
| To avoid possi |
|
| fatal injury, D |
Counterbalance Cable
Cut off excess cable. | in First Groove | |
Cam Peak Strait Up | ||
|
IMPORTANT: Ensure the cable is aligned and seated in the First groove of the cable drum prior to winding springs.
NOTE: Illustrations show the right | Pliers | Set Screw |
|
TorqueMaster® Plus drum, left | Use | ||
Counterbalance | this | ||
TorqueMaster® Plus drum is |
|
| |
| Cable |
| |
symmetrically opposite. |
|
| |
|
|
| |
Please Do Not Return This Product To The Store. Contact your local | 25 | ||
yellow pages business listings or go to the Find a Dealer section online at |
| ||
