❉
Tools Needed:
Power Drill
7/16” Socket
Driver
Side Lock
Install the side lock on the second section of the door. Secure the lock to the section with (4) 1/4”- 20 x 11/16” self drilling screws. Square the lock assembly with the door section and align with the square hole in the vertical track. The side lock should be spaced approximately 1/8” from the section edge.
IMPORTANT: side locks must be removed or made inoperative in the unlocked position if an operator is installed on the door.
NOTE: After completing this step, continue with step 10 on page 16.
1/8”
(4)1/4”- 20 x 11/16” self drilling screws
❉
Tools Needed:
Power Drill
1/8” Drill Bit
Pull Rope
Measure and mark the jamb approximately 48” to 50” (1220 to 1270
mm)from floor on the right or left side of door. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.
WARNING
DO NOT INSTALL PULL ROPES ON DOORS WITH ELECTRIC OPERATORS. CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR FATAL INJURY.
NO. 6 Screw EYE
PULL ROPE
BOTTOM BRACKET
PULL ROPE
Optional INSTALLATION
Please Do Not Return This Product To The Store. Contact your local
