Xerox 4850 NPS, 4090 NPS, 4890 NPS, 4050 NPS manual General system messages

Models: 4050 NPS 4850 NPS 4090 NPS 4890 NPS

1 248
Download 248 pages 10.85 Kb
Page 106
Image 106

PRINTER CONTROLLER MESSAGES

General system messages

These messages may appear at the Printer Controller. The messages occur during general system operations, management of print jobs, and system activities that support the Xerox DocuPrint NPS system.

Message

Explanation/action

Diagnostic Job #<number> start, Service, <document name>, <timestamp>

***Error: Cancel, decomposition failed

A diagnostic job has been initiated from the service mode.

No action required.

A document has been cancelled due to a decomposition error.

No action required.

***Error: PostScript Job Aborted

PostScript Job was aborted.

 

Check the output to make sure there is no data loss.

***Error: SunRPCBinding.Error

The Job Pool Manager database may have been

[requested service not available]

corrupted. The Job Pool Manager automatically recovers

 

by replacing the corrupted database with a new one. If it

 

cannot successfully recover, you can recover it through

 

the Wizard Mode. See “Using Wizard Mode” for the steps

 

to recover the Job Pool Manager database.

Failed to cancel document

An attempt to cancel a specific document failed. This

<number>which is being processed

document was being processed at the time of the “Cancel

 

Document” entry and is ineligible for cancellation.

Fast reset requested. Restarting...

The sequencer has been restarted.

Restarting Sequencer

No action required.

fd0:read failed (4010)

You tried to read from a disk that is not the same density

fd0:bad format

as a previously read disk.

 

No action required: Unless the disk is damaged, the

 

system automatically determines the correct format of the

 

disk and performs the action you requested.

iobus level 13 interrupt not

You rebooted the Printer Controller while doing something

serviced

at the printer, such as pressing a button or opening a door.

 

Power off the Printer Controller and power it on again. To

 

avoid this error, always use the Halt System and Restart

 

System commands.

Log file is empty.

There are no messages in the specified log file.

 

No action required.

None of the specified documents

None of the specified jobs are eligible for cancellation.

can be cancelled.

 

***NVMRead Failed Command

There is a non-volatile memory (NVM) failure.

Terminated

Contact your service representative for assistance.

 

PCL error: ABORTING A PAGE

The printer aborted a page.

 

Check the output to make sure there is no data loss.

48-42

XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE

Page 106
Image 106
Xerox 4850 NPS, 4090 NPS, 4890 NPS, 4050 NPS manual General system messages