Xerox 4850 NPS, 4090 NPS, 4890 NPS, 4050 NPS manual Clear area 2a

PRINTER CONTROLLER MESSAGES

Message		Explanation/action
		1.	Clear area 2a.
		2.	Press the Continue button.
E227	Bottom transport trailing	The paper fed from the HCF did not leave the bottom
	edge jam.	transport switch in time.
		1.	Clear area 2a.
		2.	Press the Continue button.
E228	Top transport leading	The paper fed from one of the trays did not reach the top
	edge jam.	transport switch in time.
		1.	Clear areas 6 and 6a.
		2.	Press the Continue button.
E238	Rotator Top transport	The paper fed from one of the trays did not leave the top
	trailing edge jam.	transport sensor in time.
		1.	Clear areas 6 and 6a.
		2.	Press the Continue button.
E243	Low fuser oil detected --	Fuser oil is too low.
	call service.	Call for service.
E244	Low fuser oil detected.	Fuser oil is too low.
		Add two tubes of fuser lubricant.
E248	Transfer blade paper size	Improper paper size.
	fault.	Install or select the larger paper size.
E250	Transfer blade solenoid	The transfer blade solenoid failed to engage during
	failed to engage.	initialization.
		1.	Press the Continue button.
		2.	Check the output for print quality.
E251	Transfer blade solenoid	The transfer blade solenoid failed to disengage during
	failed to disengage.	initialization.
		1.	Press the Continue button.
		2.	Check the output for print quality.
E278	Toner waste container	The toner waste container access door is open. The toner
	access door (rear door)	waste container access door must be closed when the
	open.	printer is in standby in order to clear a fault. This prevents
		a door from opening and closing during printing without
		generating a fault.
		1.	Close the toner waste container access door.
		2.	Press the Continue button.
E279	Color developer housing	The color developer housing is not present in the printer.
	is not present.	1.	Open the front left door.
		2.	Install a color developer housing.
		3.	Close the left front door.

48-18 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE